11-26-2015, 01:14 PM
|
|
Master Modeler
|
|
Join Date: Mar 2005
Location: Illinois
Posts: 792
|
|
Good hearing from you, Chris, Thanks.
Take the Core tube and add masking tape strips around the top of the Core tube.
Turn the tube over so the top of the core tube is facing down with the sticky side of the tape facing up.
Get the main shroud, slide the shroud down over the core tube lining up the joint of the Core tube and shroud. Slide the shroud down to the bottom of the Core tube. You can turn over the Core tube and shroud to see if the top of the shroud and Core tube is aligned. If you are satisfied with the shroud and Core tube assembly, turn the Core tube and shroud back over and spot glue to keep the two pieces together.
|