View Single Post
  #17  
Old 11-27-2015, 04:42 PM
the mole's Avatar
the mole the mole is offline
Master Modeler
 
Join Date: Mar 2005
Location: Illinois
Posts: 792
Default

Now that we have the subassembly done, it's time to put them together.

Take the Core tube and Main shroud assembly and turn them over. Position the ring over the core tube so it is in contact with the main shroud. Make sure the Hatchway lines up with the wide portion between vents on the ring. Apply glue to each of the 6 locations where the ring touches the core tube. Let dry.

With the glue dry, turn the assembly over and glue the main shroud to the outside of the ring.
In my picture I used little strips of masking tape to hold the shroud down on the ring while I applied glue to the main shroud and ring around the hold assembly.

After the glue on the shroud and ring is dry, position the minor shroud over the core tube. Align the plain portion of the minor shroud with the wide portion between the vents on the ring. Apply glue to minor shroud and let dry.
Attached Thumbnails
Click image for larger version

Name:  20151123_085024.jpg
Views: 78
Size:  532.9 KB  Click image for larger version

Name:  20151123_085639.jpg
Views: 101
Size:  235.1 KB  Click image for larger version

Name:  20151123_085903.jpg
Views: 79
Size:  297.5 KB  Click image for larger version

Name:  20151123_092616.jpg
Views: 75
Size:  405.8 KB  Click image for larger version

Name:  20151123_095829.jpg
Views: 86
Size:  181.6 KB  
Reply With Quote