01-15-2019, 09:36 PM
|
BAR 13790
|
|
Join Date: May 2008
Location: Johnson City, NY
Posts: 525
|
|
Realized I could work the fins ....
Since I changed the nose cone I needed to verify the template for the fin. Of course it doesn't line up. I adjusted the pattern by eye and only had to do a second try. Dumb luck! It lines up fairly well now.
But now it is too big for the sheet of balsa supplied. So I cut a corner off and glued it back on. Some water for weight while drying.
I also discovered that cutting 1/4" balsa is not easy. Cutting the curves will be "fun"
|