03-04-2011, 09:36 PM
|
|
BARCLONE Rocketry
|
|
Join Date: Mar 2005
Location: Mobile, Alabama
Posts: 5,357
|
|
Estes #2015 Strikefighter - Fins, Parts & Guides
Whew!
This one was a toughie, fer sure...
Four patterns: - Fins -- 2 sheets required, 3/32" balsa
- Thin trims -- one sheet required, 0.02" matteboard or cardstock
- Rings and cooling fins -- one sheet required, 0.05" matteboard
- Alignment guides -- one sheet required, 0.05" matteboard
I made one cosmetic change to two of the rings used on the pods. The rear openings of the pod core tubes were filled with a simple ring that had a hole in the center for a launch lug size tube. I opted for a more detailed ring with some "pseudo spinning blades" burned into the surface. I thought it looked a little better than just a plain ring...
I did not include the engine tube centering rings, as these are common-stock CR-2055...
|