View Single Post
  #283  
Old 09-13-2018, 07:19 PM
BARGeezer BARGeezer is offline
Avid Builder
 
Join Date: Nov 2017
Posts: 610
Default

Received my replacement A and B Q-Jet motors today ( with the narrower diameter casing). Tried it in a few motor mounts, fit every one. Was expecting a piece of heat shrink tubing to hold the igniter in the nozzle but nada. Instructions say to use a piece of masking tape. Only heat shrink is attached to the lead wires to mark the correct position for inserting.


Also saw an announcement on the Quest website that the C and D motor pre-orders will start shipping shortly after Labor Day weekend, and it might take up to two weeks to clear the backlog. Haven't received a shipping notice yet for my pre-order. Twiddling thumbs, drumming fingers......
Reply With Quote