03-22-2018, 11:10 AM
|
|
Mr. Cut-by-hand
|
|
Join Date: Nov 2015
Location: Northern New Jersey
Posts: 439
|
|
"Body bands"
There are four "body bands" (eljefe, help me out here). They are implemented by wrapping 1/32" balsa sheet around the body. Wrapping with the grain, the balsa can easily conform to BT55 diameter without any special steps taken. Because I could only get 1/32" balsa 3" wide, I needed to use two pieces for each band.
Then, because I am insane, I papered them, using my standard Avery label paper technique.
Final picture shows confirmation that everything is in the right place by holding up a paper fin template.
|