04-03-2019, 06:54 PM
|
 |
Master Modeler
|
|
Join Date: Jan 2009
Location: Fairbanks, Alaska
Posts: 6,507
|
|
Quote:
|
Originally Posted by teflonrocketry1
You would need a 3D scan as the hinges are more than just flat parts!
I searched around for the 3D printer files for these 2 hinges, the rear launch lug and pitot tube and was unable to find anything. Here is a link to the instructions that shows these parts http://plans.rocketshoppe.com/estes/est1336/est1336.pdf The 2 hinges hold the wings and also make up the forward launch lug. |
Was the Centuri ALCM kit identical--or at least very similar--to the Estes one (or at least close enough that its hinges could be adapted for use in an Estes ALCM kit [much as how the Centuri and Estes 1:100 scale Saturn V kits' parts could, in some cases, be substituted for each other]?). |