#21
|
||||
|
||||
Quote:
I ordered the parts to clone a SST Shuttle over the winter and it's all done except for the ramjet parts. I was going to try and make them myself but never got around to it and didn't get around to ordering the resin parts either. If they are available, I would like to buy a set also. I wish the laser cut fin sets had been available last winter. Cutting them out was a slight pain. |
#22
|
||||
|
||||
Quote:
Nope - I went through PayPal. |
#23
|
||||
|
||||
Hey Carl,
I got my SST Shuttle from you about 10 days ago....I did not get the free Aerobee-Hi kit. From these postings on this thread, I should have ? My EXTREMELY LOW production number is #00008 !!!!! Were there any publicly available lower than this one ? I'll send you a P.M. Jerry Last edited by ghrocketman : 08-08-2005 at 09:30 PM. |
#24
|
||||
|
||||
Quote:
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
#25
|
|||
|
|||
Quote:
I see that they are also selling some Quest motors now.
__________________
Scott D. Hansen Ye Olde Rocket Shoppe - Your One Stop BAR Shoppe! Ye Olde Rocket Plans - OOP Rocket Plans From 38 Companies! Ye Olde Rocket Forum WOOSH NAR Section #558 |
#26
|
|||
|
|||
Quote:
Thanks Carl! I really wasn't expecting one since I placed an order prior to NARAM special announcement. It is very much appreciated.
__________________
Quando Omni Flunkus Moritati |
Thread Tools | Search this Thread |
Display Modes | |
|
|