#11
|
|||
|
|||
Thanks in advance, Craig!
I sure so appreciate it! Allen |
#12
|
||||
|
||||
OK, these represent the last-known-good RockSim outlines for the Hyper Alpha, posted as "Rev 5.0". The files are saved in Corel Draw 10 "CDR" format, which Carl can feed directly into his Death Ray.
I did not try to optimize the patterns beyond making them easier to fit onto the sheets, and aligning the grain patterns to the leading and trailing edges. The balsa thickness was called out as 3/32", but the same pattern can be used for 1/8" if you prefer. Just let Carl know if you decide to go that route. Note the antennas are both on the balsa sheets and on a separate matteboard sheet. Builder's option...
__________________
Craig McGraw BARCLONE Rocketry -- http://barclone.rocketshoppe.com BARCLONE Blogsite -- http://barclone.wordpress.com BARCLONE Forum -- BARCLONE Forum BARs helping BARs SAM 0044 AMA 352635 Last edited by CPMcGraw : 02-26-2012 at 05:54 PM. |
#13
|
|||
|
|||
Thanks, again, Craig! I'll get in touch with Carl to make me up a set!
Allen |
Thread Tools | Search this Thread |
Display Modes | |
|
|