#11
|
||||
|
||||
That sounds like a good solution. I have a couple of 900mm Maker Beams including one I fairly crudely drilled out the end of and epoxied in a bit of Estes starter set launch rod in so I can put it on a PortaPad or any other pad that can take a 1/8 inch rod by grasping the rod itself. I should try the micros again.
That Plastruct looks like a good idea, too.
__________________
Bernard Cawley NAR 89040 L1 - Life Member SAM 0061 AMA 42160 KG7AIE |
#12
|
||||
|
||||
I cannot find my package of styrene I-beam that I bought for the MakerBeam rail. And I even have a box for all my styrene parts.
I had taken my rail to HobbyLobby and looked at all their structural styrene until I found one that was a good fit. When I looked at my packages, I have Evergreen as well as a Plastruct, so it could be either.
__________________
Lee Reep NAR 55948 Projects: Semroc Saturn 1B, Ken Foss Designs Mini Satellite Interceptor In the Paint Shop: Nothing! Too cold! Launch-Ready: Farside-X, Maxi Honest John, Super Scamp |
Thread Tools | Search this Thread |
Display Modes | |
|
|