#1
|
||||
|
||||
Interesting ducted ejection 24mm design
Another one I just can't think of a name for.
This design was inspired by something I saw on another forum. All the balsa blocks are carved out to allow the BT-3 tubes to run straight from the base to the top. These tubes pass the ejection charge up to the nose to pop the nosecone. The centering rings are also notched. These will hopefully create strength in the center part so the BT-3s won't buckle during flight or landing. Good numbers for the most part. Enjoy!
__________________
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- Dale Marshall, San Antonio Texas NAR #90990 Semroc SAM #083 BAR Since 2008 Enjoying model rocketry since 1977. The Spotted Dragon -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- |
#2
|
|||
|
|||
Is it done yet?
Quote:
__________________
Scotty Dog NAR 90998 |
Thread Tools | Search this Thread |
Display Modes | |
|
|