View Single Post
  #3  
Old 12-16-2007, 09:05 PM
CPMcGraw's Avatar
CPMcGraw CPMcGraw is offline
BARCLONE Rocketry
 
Join Date: Mar 2005
Location: Mobile, Alabama
Posts: 5,357
Default

Quote:
Originally Posted by Thruster
What are some of the tools needed to make scratch building easier, I have the Estes tube marking tool but what are some of the other tools and tricks?


1. A 12" steel ruler for making straight cuts with your X-Acto knife...
2. More than one X-Acto #1 knife with a fresh blade...
3. A spare pack (or two) of fresh #11 blades for your X-Acto knife...
4. 3 oz paper bathroom cups...
5. Assorted artists brushes...
6. A "T-Bar" or other aluminum sanding block...
7. An assortment of sanding papers, with a larger portion of 220-grit...
8. A can of 3M-77 spray contact adhesive...
9. A Zona saw, or a #3 X-Acto handle with fine-tooth cutting blade...
10. A set of disposable kitchen cutting mats...
11. Various mechanical pencils and fine-tip pens...
12. A pair of tri-edge rules, one Archetectural, one Engineering...
13. Numerous holding stands; wooden base with a dowel and an expended motor casing on one end, or some empty CD/DVD spindles...
14. A pack of sanding twigs -- foam strips 3/32" and 1/8" wide, 6" long, with sandpaper glued to two sides...
15. Various widths of masking tape...
16. A computer with a good graphics program (Corel Draw, Photoshop, The GIMP) to create patterns with...
17. Stack of #110 cardstock, to create templates and patterns made with your computer...
18. A decent color printer...
19. T-Pins...
20. Wax paper...
21. Various viscoscities of CA glue...
22. Small bottles of yellow glue...
23. A large bottle of yellow glue to refill the small bottles from...
24. A notebook to sketch ideas in...
25. A scrap bin, to catch bits and pieces of discarded balsa and tubing in...
26. An office "cubbyhole" shelf unit for holding your cardstock, decal sheets, etc...
27. Tack rags...
28. A good air compressor, 5-6 HP, oilless, with a good regulator...
29. Several inexpensive airbrushes for colors, and at least one or two larger detail guns for spraying primer and base whites. Don't use any gun with multiple types of paint; only use one type of paint with any one gun or airbrush to avoid gumming internally.
30. Two or three dozen fresh 1 oz jars to fit the airbrushes, and several jar adapters...
31. Paint thinners by the gallon. It's much cheaper...
32. Wooden clothespin clamps, with the wood pieces turned upside down...
33. Rubber band clamps...
34. Small one-hand "pressure/tension" bar clamps... (Perfect for us, No?)
35. Patience...
__________________
Craig McGraw

BARCLONE Rocketry -- http://barclone.rocketshoppe.com
BARCLONE Blogsite -- http://barclone.wordpress.com
BARCLONE Forum -- BARCLONE Forum

BARs helping BARs

SAM 0044
AMA 352635
Reply With Quote