Wow! What you have there is great already! I've started to design the battery holder and other supports, but you're much further along than I am.

It seems my board measurements from the manual were spot on!

Don't worry about measuring everything on the board. The holes for each component may end up not being exactly what they were back then due to part availability. I've already started the KiCad board layout, so I'll be going with that for the board order.

One item that will be of use though is the outside diameter of the two coil forms. I have the correct size slugs as samples from micrometals.com, so the outside diameters will be a great help.

Thanks!

-Frank

Attached Thumbnails