Quote:
|
Originally Posted by Newbomb Turk
It looks like the nose cone is the rounded BC-730P. The Semroc parts list calls it BC-730, but there is only 730G and 730P.
|
Newbomb,
I agree completely. The BC-730P is a direct substitute for Centuri's original PNC-76.
Quote:
|
Originally Posted by Vanel
Nope - all I have is the Lancer info on the Semroc site.
Would appreciate anything you can provide!
|
Bill,
I looked through my old printouts, but there wasn't anything else listed for the Lance Corporal than what little is still on the old Semroc site.
However, I think we can approximate the L-C nonetheless.
I recommend adding two ST-730s (one for the payload section, the other for the booster stage). You'll need a BTC-7 connector for the payload section, and an HTC-7B (don't forget the "B!") for the first stage.
(I also recommend substituting a single ST-790 for the original Lancer's ST-760 and ST-730 tubes. It'll save you the original internal HTC-7 connector.)
Attaching the first stage to the sustainer could be tricky, though. I recommend taking a look at Centuri's Black Widow to see how it was done on that model.
Granted, the B-W first stage body tube was 4" long instead of 3", but at least that's a start.
Please note the excerpt from my current documentation project below. Thanks!
.
__________________
Jay Goemmer
"Centuri Guy"/"Tau Zero"
YORF Member 28
Semroc SAM #0029
NAR 86131
"I think about organizing things all the time. Never seems to happen. I find something that piques my interest and I'm off on a quest. Or a Centuri.
"
--Bill Eichelberger, 02/22/2022
“Centuri fret buzz in an updated form.”
Bill “Wallyum” Eichelberger re: Estes Flutter-By
03 Sept 2014