10-05-2019, 05:59 PM
|
|
frustrated aero
|
|
Join Date: Sep 2006
Location: Duncan, OK
Posts: 834
|
|
I built a pretty standard engine mount following the directions from the Estes K-30 model, even adding the balsa gussets. I cut a set of centering rings from 0.050 mat board.
I had planned on running a piece of Kevlar line through a hole in the top centering ring, looping it around the engine tube, and back out another hole in the CR, but got in a hurry and glued the mount into the tube!!! I will use Kevlar and a standard shock cord paper mount epoxied to the body tube instead.
|