View Single Post
  #8  
Old 05-18-2014, 11:35 AM
johnnwwa johnnwwa is offline
BAR
 
Join Date: Apr 2005
Location: Washington State
Posts: 467
Default

Quote:
Originally Posted by sandman
OK, I've redrawn everything as a pdf and included a 1" square to verify your print.

I did make a change on the lower intake centering rings.

The change makes the model much stronger. Instead of cutting the main body tube, you leave it intact and cut the intake tube.

It looks the same.

Let me know if those open OK.

I also did some upscales. Just let me know if you need them.

BTW I made a BT-70 upscale and moving it around was almost dangerous.

Watch out for the wing and fin probes...they WILL put your eye out!


Ring set is incomplete the patterns for the inlets is not finished ( the four on the right )
both open with no problem.
__________________
John

NAR #91135 L1
SAM #0037
Reply With Quote