12-23-2019, 06:50 PM
|
BAR
|
|
Join Date: Nov 2005
Location: WI
Posts: 1,852
|
|
I need to figure out how to get a CR in the tapered tail cone. Ideally it will be at the aft end of the fin tabs, so I can glue them well to the MMT. The problem here is how to get it in there? I'll need to glue the tail cone in, then the fins - but the aft opening is far too small to get anything in there. Even if I remove all the aft support, the TC is still tapered...
__________________
Paul
If we weren't all crazy, we would go insane - Jimmy Buffett
NAR #87246 www.wooshrocketry.org
|