#21
|
|||
|
|||
John, I noticed that your JT-80C is also cut rough like mine in both my kits. I am only currious, did Estes cut there own tubes? Mine look pretty bad, heck I think I could have done a better job. I am only wondering because it seems it would have taken a long time to cut a bunch of these tubes by hand. I thought Estes ordered there tubes pre-cut from a dealer.
|
#22
|
||||
|
||||
Quote:
Hi; I think my photo makes the edges look worse than they are, most likely because of the depth of field. My part appears to have the same factory edge that most Estes tubes have, so I'm pretty sure it was cut by their tube vendor. Estes outsourced tubes after just a couple of years of operation, it seems.
__________________
John YORF #003 SAM #004 |
#23
|
||||
|
||||
Quote:
I have a couple of these at the house, one left over from my Super Big Bertha interpretation I thought they were kinda wimpy, but, since these were intended to be mated permanently to both tubes, they don't need to be very long nor any stronger than the tubes being joined. So I concluded they are in fact up to the task (when used with perfectly square cut tubes as is generally the case with Estes). BUT, since we all like to break our SBB's, Comanches, et al, in the middle, then an aftermarket coupler is a must. As a result, I have these leftovers. One of these days, I need to put all my undersized/leftover motor tubes, parachutes and shock cords on Ebay along with my 21mm FSI parts Doug |
#24
|
||||
|
||||
Estes Star Rider 2010 decals
Quote:
Has anybody redrawn the Estes Star Rider #2010 decals? If so, can you point me to a link? Thanks in advance.
__________________
Jay Goemmer "Centuri Guy"/"Tau Zero" YORF Member 28 Semroc SAM #0029 NAR 86131 "I think about organizing things all the time. Never seems to happen. I find something that piques my interest and I'm off on a quest. Or a Centuri. " --Bill Eichelberger, 02/22/2022 “Centuri fret buzz in an updated form.” Bill “Wallyum” Eichelberger re: Estes Flutter-By 03 Sept 2014 |
#25
|
||||
|
||||
Estes Star Rider 2010
Sorry, another nitpicking update on this archaic thread.
Quote:
Quote:
Quote:
12.7" = 323 mm, instead of 350 mm as noted on the original Estes instruction sheet. Anal retentive? Sure. To a former TV news reporter? No. A minor detail, yes, but now my brain can stop spinning. Moving on,
__________________
Jay Goemmer "Centuri Guy"/"Tau Zero" YORF Member 28 Semroc SAM #0029 NAR 86131 "I think about organizing things all the time. Never seems to happen. I find something that piques my interest and I'm off on a quest. Or a Centuri. " --Bill Eichelberger, 02/22/2022 “Centuri fret buzz in an updated form.” Bill “Wallyum” Eichelberger re: Estes Flutter-By 03 Sept 2014 Last edited by Tau Zero : 05-31-2020 at 04:16 PM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|