#1
|
|||
|
|||
ST13 1.34” OD tubing - where to find
Does anyone know where I can find this stuff? It’s outta stock at erockets and I’m stumped as to where else one might find it.
TIA |
#2
|
|||
|
|||
ST-13 is 34.6mm OD.
The closest I have been able to find is Quest 35mm body tube.
__________________
Bob S.A.M. # 0014 |
#3
|
|||
|
|||
Thanks Bob. That’ll probably work.
Btw I am posting some way odd parts at the other forum. You might pop in. |
#4
|
||||
|
||||
ST-13 has been unavailable for quite some time.
__________________
When in doubt, WHACK the GAS and DITCH the brake !!! Yes, there is such a thing as NORMAL, if you have to ask what is "NORMAL" , you probably aren't ! Failure may not be an OPTION, but it is ALWAYS a POSSIBILITY. ALL systems are GO for MAYHEM, CHAOS, TURMOIL, FIASCOS, and HAVOC ! |
#5
|
|||
|
|||
Quote:
Along with ST-7
__________________
Andrew A NAR 33674 SAM 0139 |
#6
|
||||
|
||||
Semroc had it.
eRockets lists several (Semroc legacy), but the longer tubes are all out of stock. Some shorter ones are available. https://www.erockets.biz/st-13/
__________________
Contest flying, Sport flying, it's all good..... NAR# 18723 NAR.org GeorgesRockets.com Georges'CancerGoFundMe: https://www.gofundme.com/f/help-geo...ay-fight-cancer |
#7
|
||||
|
||||
It is heavy duty tube for Enerjet clones but LT-125 has that OD:https://www.erockets.biz/semroc-bod...0-discontinued/
Last edited by 5x7 : 01-09-2023 at 07:16 AM. |
#8
|
||||
|
||||
Quote:
But if one wanted to use a ST-13 nose, or old old Egg Crate payload section, or an old Astrocam (which IIRC used the ST-13 sized tube instead of BT-55), the inside diameter would be too small. Also, would need custom centering rings. Although if a person had an old slide-on plastic fin unit, then that tube would work (albeit the nose cone issue).
__________________
Contest flying, Sport flying, it's all good..... NAR# 18723 NAR.org GeorgesRockets.com Georges'CancerGoFundMe: https://www.gofundme.com/f/help-geo...ay-fight-cancer |
#9
|
||||
|
||||
I would slice off the NC shoulder and glue in the LT-125 balsa coupler if they are still available. I have a couple of old AAA kits that use that method.
|
Thread Tools | Search this Thread |
Display Modes | |
|
|