#19
|
||||
|
||||
I’m not sure there are brass bits, since brass is so soft. I turn brass on my wood lathe, using HSS lathe tools. The picture shows a tool handle I turned, with a brass plumbing hex nut used as a ferrule to strengthen the handle. Some exotics woods I’ve turned are more difficult to cut than brass.
One solution may be to use a piece of brass tubing to drill out the core. Perhaps cutting an angled tip, to prevent clogging, and also to make it easier to sharpen the tip, might work well.
__________________
Lee Reep NAR 55948 Projects: Semroc Saturn 1B, Ken Foss Designs Mini Satellite Interceptor In the Paint Shop: Nothing! Too cold! Launch-Ready: Farside-X, Maxi Honest John, Super Scamp |
Thread Tools | Search this Thread |
Display Modes | |
|
|