#1
|
|||
|
|||
Asm
Does someone have the plans for the Airbourne Surveillance Missile (Estes, kit #0867). They are on Jim Z's site. However they are so small you can't read them and they won't enlarge. They won't print out either.
|
#2
|
||||
|
||||
Here, try this. If I have a chance I'll draw up the fins for you. Otherwise just use the scan and cut from balsa.
Make sure that when you print the files, your printer driver is set to no scaling or NOT to "fit to page". |
#3
|
||||
|
||||
Are you clicking on the thumbnails to open the tif file? I get a full sized image which would print out fine. I have set my PC to open tif files with the "Microsoft Office Document Imaging" software on my machine. You may have to download a tif image viewer, if you don't have MS Office installed.
On the thumbnail, right mouse click and "Save Target As" (NOT "Save Picture As") to get the full size image. |
#4
|
|||
|
|||
THese worked fine for me - I just printed a set last week after Gordy posted he had the decals
I have a vintage builtup I can measure, but always easier to download the patterns. Also , I dropped a note to Carl about the rings - would be nice to have the top ring that the dowels sit on ... that will be a pain to make up ( glue pattern to some .050, then cut out and dsand to look presentable ) . I always liked this bird, and will be neat to see some being built, one of the overlooked classics. ~ AL now to dig out that 7.7" cone I have.. hmmm..... |
#5
|
|||
|
|||
Asm
Thanks for the help/info. I'd like to do a 2.6 or 3 inch upscale if I can find a nose cone.
|
Thread Tools | Search this Thread |
Display Modes | |
|
|