#1
|
||||
|
||||
Centuri Mach 10 #KA-4
Attached is a RockSim simulation and screen shots of the simulation for the Centuri Mach 10 that I am cloning. I plan to follow the instructions and measurements posted at the JimZ site. I used an 8" section of BT-60 for the main body since there is no way to easily remove the internal nosecone on the model with an 8.5" long body and a 6.5" long motor tube, I actually mocked this up and tried it. This simulation contains pods, therefore it is not compatible with Openrocket software.
The glue is still drying on the model in the picture, it has 3D printed ABS nosecones, BT-60, BT-20 and BT-5 instead of the Centuri tubes, I used 1/16" basswood instead of 3/32 balsa.
__________________
Bruce S. Levison, NAR #69055 Last edited by teflonrocketry1 : 02-10-2019 at 03:57 PM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|