#11
|
|||
|
|||
Thanks for all of the info. I'll get that parts catalog for sure and ask Estes customer service when I call about the Skywinder rotor blades I need.
I went out to the garage and started on one from Delryn but I turned a little too much off of the shoulder for the Bandit. It fits the BT-20 tube I got from Semroc perfectly. I just have it rough drilled now, but once I bore it out to a thin wall it should work fine for whatever I make out of the BT-20. I have several other cones that I've turned and bored from Delryn and Nylon. They aren't quite as light as a balsa cone, but they work well and are nearly indestructable. I actually lawn darted one into the street with a Nylon cone and the rocket bounced about 6 feet off of the ground, totally destroying the BT, and pretty much everything else, but the cone just needed a little sanding and it was fine. I'm not sure why the picture is this big, sorry. Last edited by my65pan : 08-13-2006 at 05:36 PM. |
#12
|
||||
|
||||
You can resize it on the Photobucket website.
If it's just the shoulder that's a little small and not the full diameter, just add a little masking tape to make it fit snug. Lots of Estes nosecones have to be done that way too. |
#13
|
|||
|
|||
After I turned the shouder down too far I just went ahead and turned the whole thing to fit BT-20.
|
#14
|
|||
|
|||
I have a couple of nose cones for the HBT-1090 - pm me with your mailing address, and I'll send you one.
__________________
Up next: Under construction: Under repair: In finishing: Centuri Sabre clone In primer: In paint: Ready for decals: Bill Cooke NAR #31312 TRA #19705 SAM #0001 Huntsville, AL My rocket blog My rocket fleet |
#15
|
||||
|
||||
Love that receiver it's sitting on.
Ham or SWL?
__________________
Craig McGraw BARCLONE Rocketry -- http://barclone.rocketshoppe.com BARCLONE Blogsite -- http://barclone.wordpress.com BARCLONE Forum -- BARCLONE Forum BARs helping BARs SAM 0044 AMA 352635 |
#16
|
|||
|
|||
Thanks Vanel, I'll PM you.
CP the unit it is sitting on is actually a Henry 2KW transmit amplifier for ham radio. |
#17
|
|||
|
|||
I just realized that what I was calling BT-20 is actually series 10 tube. I was looking at my Semroc reciept when I typed in BT-20. I bought a length of BT-20 to use for motor tube and some series 10 for a BT. I got them confused, I'm a newby:-).
|
#18
|
||||
|
||||
Post a good pic and I can make some.
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
#19
|
|||
|
|||
Quote:
Carl, if you figure there's enough demand / want to add this one just in case, let me know, I can send a PNC for you to measure / copy. ( actually, I should have both the short and longer versions laying around ) ~ AL |
#20
|
||||
|
||||
Quote:
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
Thread Tools | Search this Thread |
Display Modes | |
|
|